REMODEL
YOUR BASEMENT
EVEN IF IT IS LOWER THAN
THE NEIGHBORHOOD SEWER LINE
|
SPECIALTY COMMODE |
4317 LaVista
Rd,
Tucker, GA 30084 |
|
REMODEL
YOUR BASEMENT |
|
|
|
The Specialty
commode is simplicity itself to install; there are just four connections.
The Specialty commode is a system that is used to install a complete bathroom up to 20 feet below the sewer line, or even up to 150 feet away from a soil stack. • The macerating pump is connected to the spigot of a horizontal outlet toilet. • The toilet tank is connected to the water supply. • The macerating/pump is connected to the small diameter discharge pipe work. • The macerating/pump is connected to the electrical supply. The inside of the Specialty commode comprises of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and the pump. |
|
In addition to the toilet waste,
Specialty commode
will also discharge gray wastewater from a variety of other sanitary
fixtures, such as: a hand basin, a bath, a bidet, a urinal and even a
clothes washer. When adding a bathtub, a base will have to be constructed,
made out of 2" x 6" on edge, to allow for the installation of a P-trap and
some gravity flow towards the pump unit. The wastewater from other sanitary fixtures is discharged into Specialty commode via two 1 1/2-inch inlets, on either side of the housing. Either one or both inlets can be used as required. The discharge elbow on top of the Specialty commode can be turned either to the left or to the right, depending on the discharge installation. The Specialty commode is designed to provide vertical pumping up to 20 feet as well as a horizontal discharge, therefore a simple ball non-return valve is incorporated. It has now become possible to install a complete bathroom where previously this would have been impossible or where considerable capital equipment and structural work would have been necessary. The water closet the Specialty commode is connected to, uses much less water than a regular toilet, it uses 6 liters (1.6 USG) of water per flush. |
|
|
FOR MORE
INFORMATION |
